Basically the falco is ready to be fiberglassed. The fiber is on the wing.

After a lot of sanding and filling work it's time to prime all the falco. This is just a first layer of primer, that is going to be sanded off to find the low spots.

 

After the primer it's time to finish the canopy skirt. We made them in fiberglass and then there's the need to seal against water. We used Stika , a product used in marine applications.

 

we worked a lot to have a good alignement between the windshield and the canopy. the result is quite good.

 

The falco is primed and ready to be rolled over.. It need the same work in the lower side of the wing. the difficult thing is that the room height doesn't allow it to be done inside. So we needed to brake the side wall.